Komatsu — eebm001902 a3.pdf

TESTING AND ADJUSTING GOVERNOR MOTOR LEVER STROKE TESTING AND ADJUSTING GOV- ERNOR MOTOR LEVER STROKE 1. Testing # Use the governor motor adjustment mode. a. Preparatory work i. In the time mode display, keep the time switch + travel speed R.H. switch + working mode R.H. switch pressed for 2.5 seconds. # The engine output when the engine is running at full throttle is the output when the power max. switch in the active mode is ON, so use this mode instead of turning the power max. switch ON. ii. Set the fuel control dial to MAX and the autodeceleration switch to OFF. # Any working mode can be used. b.

In this condition, check that governor lever (4) is in contact with FULL stopper (5) of the injection pump. c. After checking, repeat the procedure in Step 1-a. to complete the governor motor adjustment mode. 2. Adjusting a. Turn the starting switch OFF, then remove the nut and disconnect joint (1) from governor lever (4). b. Repeat the procedure in Step 1-a. above to set to the governor motor adjustment mode. c. Set governor lever (4) to a position where it con- tacts FULL stopper (5) of the injection pump, then adjust the length of spring assembly (2) and rod (3), and connect joint (1) with the nut. d.

From the above position, turn rod (3) back 2 turns (retract the rod approximately 2.5 mm) and se- cure in position with locknuts (6) and (7). Caution When the spring assembly is removed and the start- ing switch is at the OFF position, if the governor motor lever is moved suddenly, the governor motor will gen- erate electricity, and this may cause a failure in the governor controller. 20-33