Komatsu — eebm001902 a3.pdf

TROUBLESHOOTING E-MODE E-5 [E306] Abnormality in feedback potentiometer system is displayed # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if the service code E is not displayed, the problem has been removed. # Before carrying out troubleshooting, check that all related connectors are properly inserted. # Always connect any disconnected connectors before going on to the next step.

# If E308 also occurs at the same time, check the wiring harness between C03 (female) (7) - X07 (6) - E06 (female) (1) short circuiting with ground or contact with other parts of the wiring harness. Table 1 E-5 Related electric circuit diagram Engine throttle pump controller 20-117 2 YES Is resistance between YES each pin of C03 (fema-le) (4) (7) (14), or between 1 each pin and chassis as shown in Table 1? Is resistance between E06 (male) • Turn starting switch NO (1) - (2), (2) - (3) as OFF. shown in Table 1? • Disconnect C03. • Turn starting switch OFF.

NO • Disconnect E04 Cause Remedy Defective engine throttle, pump controller Defective wiring harness in system with defective resistance Defective governor motor Replace Replace Replace C03 (female) E046 (male) Resistance value (7)-(4) (1)-(2) 2.5-7kq (14)-(17) (2)-(3) 2.5-7kq (7)-(17) - 2-3kq - (1)-(3) 4-6kq Betweenchassis andpins Betweenchassis - andpins MNoin c.on1tinMuiqty