TROUBLESHOOTING C-MODE 20-160 Condition when normal (voltage, current, resistance) Action by controller when abnormality is detected Problem that appears on machine when there is abnormality • Resistance of solenoid: 7 - 14 q 1. Makes output to solenoid 0. 2. Displays user code E02 on monitor panel. # If the abnormality is restored by the vi- bration of the machine, it resets the power source to restore to the proper condition. (However, the service code display does not go out). 1. No current flows to the pump EPC solenoid. Therefore, when the load is large, there is a big drop in the engine speed which may re- sult in the engine stalling. • Resistance of solenoid; 7 -14 q • Current:
1000mA (H/O mode, auto-deceleration ON, levers at neutral, fuel control dial at MAX.) 1. The current stops flowing to the solenoid, so no particular action is taken. 2. If there is a short circuit with the ground at the (-) end, the current (min. 1A) contin- ues to flow to the solenoid. 3. It displays user code E02 on the monitor panel. # If the abnormality is restored by the vibra- tion of the machine, it resets the power source to restor to the proper condition. (However, the service code display does not go out.) 1. In the case of 1, it is the same as E232. 2. In the case of 2, the current (min.
1A) continues to flow to the front pump PC solenoid, so the output of the front pump PC valve in- creases and the overall speed be- comes slower. • Resistance of solenoid: 20 - 60 q 1. Makes output to PC solenoid 0. 2. Displays user code E03 on monitor panel. # If the abnormality is restored by the vibra- tion of the machine, it resets the power source to restor to the proper condition. (However, the service code display does not go out.) When the swing is operated, the motor brake is not released, so the upper structure does not swing. • Resistance of solenoid: 20 - 60 q 1. The current stops flowing to the PC sole- noid, so no particular action is taken. 2.
It displays user code E02 on the monitor panel. # If the abnormality is restored by the vibra- tion of the machine, it resets the power source to restore to the proper condition. (However, the service code display does not go out.) Same as display E203.