Komatsu — eebm001902 a3.pdf

TROUBLESHOOTING C-MODE 20-162 Condition when normal (voltage, current, resistance) Action by controller when abnormality is detected Problem that appears on machine when there is abnormality • Resistance of solenoid: 20 - 60 q 1. Makes output to solenoid 0. # If the abnormality is restored by the vibration of the machine, it resets the power source to restore to the proper condition. (However, the service code display does not go out.) The pump merge/divider valve continues to merge the oil flow. 1. In the L/O modes, the work equipment and swing speeds become faster. 2. The steering is difficult to turn. • Resistance of solenoid: 20 - 60 q 1. Makes output to solenoid 0.

# If the abnormality is restored by the vibration of the machine, it resets the power source to restore to the proper condition. (However, the service code display does not go out.) There is no power when travel- ling or when power max. func- tion is used (relief pressure is not increased). • Resistance of solenoid: 20 - 60 q 1. Makes output to solenoid 0. # If the abnormality is restored by the vibration of the machine, it resets the power source to restore to the proper condition. (However, the service code display does not go out.) Even if the travel speed is switched, the travel speed does not change (travel motor swash plate angle MAX). • Resistance of solenoid: 20 - 60 q 1.

The current stops flowing to the sole- noid, so no particular action is taken. # If the abnormality is restored by the vibration of the machine, it resets the power source to restore to the proper condition. (However, the service code display does not go out.) In the standard mode (active mode OFF), the boom LOWER speed becomes faster. • Resistance of solenoid: 20 - 60 q 1. The current stops flowing to the sole- noid, so no particular action is taken. # If the abnormality is restored by the vibration of the machine, it resets the power source to restore to the proper condition. (However, the service code display does not go out.) Same content as display for E208 • Resitance of solenoid:

20 - 60 q 1. The current stops flowing to the sole- noid, so no particular action is taken. # If the abnormality is restored by the vibration of the machine, it resets the power source to restore to the proper condition. (However, the service code display does not go out.) Same content as display for E204 • Resitance of solenoid: 20 - 60 q 1. The current stops flowing to the sole- noid, so no particular action is taken. # If the abnormality is restored by the vibration of the machine, it resets the power source to restore to the proper condition. (However, the service code display does not go out.) Same content as display for E205