TROUBLESHOOTING C-MODE C-4 [213] Disconnection in swing holding brake solenoid system is displayed # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if an E service code is displayed. (If it is not displayed, the problem had been removed). # Before carrying out troubleshooting, check that all related connectors are properly inserted. # Always connect any disconnected connectors before going on the next step. Table 1 20-176 Between V04 (male) (1) - (2) 20 -60 Between V04 (male) (2) - chassis No continuity