Komatsu — eebm001902 a3.pdf

TROUBLESHOOTING C-MODE C-17 [E224] Abnormality in front pump pressure sensor system is displayed # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if an E service code is not displayed, the problem has been removed. # If the starting switch is turned OFF after an abnormality occurs, turn the starting switch ON and check is an E service code is displayed. (If it is not displayed, the problem had been removed). # Before carrying out troubleshooting, check that all related connectors are properly inserted.

# Always connect any disconnected connectors before going on the next step. C-17 Related electric circuit diagram C08 (x03) Engine throttle pump controller 20-190 3 YES Is voltage between C03 (3) and (16) normal? • Engine at high idling NO • Operate repeatedly arm IN relief rR lever NEUTRAL. • 0.5 - 4.5 V 4 YES Is voltage between C08 (2) and chassis normal? • Disconnect C08. NO • Turn starting switch ON.

• 18 - 28 V Cause Remedy Defective engine throttle - pump controller Short circuit with power source, defective contact, or disconnection in wiring harness between C03 (female) (3) - C08 (female) (3) Short circuit with ground, defective contact, or disconnection in wiring harness between C03 (female) (16) and C08 (female) (1) Short circuit with ground, defective contact, or disconnection in wiring harness between C03 (female) (6) and C08 (female) (2) Defective front pump pressure sensor (internal disconnection, defective contact, short circuit, or short circuit with ground) Replace Repair or replace Repair or replace Repair or replace Replace Is voltage between YES C08 (2) and (1) normal?

1 • Turn starting switch Interchange con- ON. nector with rear pump • 18 - 28 V NO pressure sensor. Is [E244] displayd? • Turn starting switch OFF. • Interchange C07 with Is voltage between C08 (2) and (1) normal?