Komatsu — eebm001902 a3.pdf

TROUBLESHOOTING C-MODE C-19 [E226] Abnormality in pressure sensor power source system is displayed # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if an E service code is not displayed, the problem has been removed. # If the starting switch is turned OFF after an abnormality occurs, turn the starting switch ON and check is an E service code is displayed. (If it is not displayed, the problem had been removed). # Before carrying out troubleshooting, check that all related connectors are properly inserted.

# Always connect any disconnected connectors before going on the next step. C-19 Related electric circuit diagram Engine throttle pump controller 20-192 YES 2 YES Is voltage between C03 (6) and (16) 3 YES normal? 1 Is voltage between • Turn starting switch C03 (6) and (16) Is resistance between ON. NO normal? C03 (female) (6) and • Disconnect C08 (16), (6) (16) and • 18 - 28 V chassis normal? • Turn starting switch NO ON. • Turn starting switch • Disconnect C07 OFF. • 18 - 28 V • Disconnect C03, C07, and C08 • Min.

1Mq Cause Remedy Defective front pump pressure sensor (internal short circuit or short circuit with ground) Defective rear pump pressure sensor (internal short circuit or short circuit with ground Defective engine throttle - pump controller Short circuit or short circuit with ground in wiring harness of system where resistance value is defective Replace Replace Replace Repair or replace