Komatsu — eebm001902 a3.pdf

TROUBLESHOOTING F-MODE F-3 Bit pattern 20-(3) Boom LOWER oil pressure switch does not light up # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if an E service code is not displayed, the problem has been removed. When measuring with the engine running, operate the lever slightly and make sure that the work equipment does not move. (When measuring with the engine stopped, charge the accumulator first). # Before carrying out troubleshooting, check that all related connectors are properly inserted.

# Always connect any disconnected connectors before going on the next step. See Note 1. Note 1: It is also possible to fit a short connector and judge the condition. In this case, check the voltage be- tween C17 (10) and the chassis. If it is 20-30 V: go to YES If it is less than 1V: Go to NO F-3 Related electric circuit diagram Engine throttle pump controller 20-196 YES 1 3 YES Is voltage between C17 (10) and chassis Is resistance between normal? YES C17 (female) (10) and S04 (female) (2) nor- 2 mal, and is circuit in- • Start engine Is resistance be- sulated from chassis? • Boom lever at neutral :

20 - 30 V tween S04 (male) (1) • Turn starting switch NO • oB po eo rm at l ee dv e tor NO a isn cd i r( c2 u) i tn io nr sm ula al t, e a dnd • O DiF sF c. onnect C17 and S04. LOWER: Max. 1V from chassis? • Between C17 and S04: Max. 1q • Disconnect S04. • Between wiring harness and chassis: No continuity • Start engine. NO • Boom lever at neutral : Min. 1Mq • Boom lever operated to LOWER: Max.

1 q Cause Remedy Defective engine throttle - pump controller Defective contact, or disconnection in wiring harness between S04 (female) (1) and chassis ground Defective contact, short circuit with ground, or disconnection in wiring harness between C17 (female) (10) - H13 (11) - S04 (female) (2) Defective boom LOWER oil pressure switch (If the condition does not return to normal even when the switch is replaced, go to H-5. Replace Repair or replace Repair or replace Replace