TROUBLESHOOTING F-MODE F-11 Bit pattern 22-(6) L.H. knob switch does not light up # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if an E service code is not displayed, the problem has been removed. # When fuse No. 5 is not blown. # Before carrying out troubleshooting, check that all related connectors are properly inserted. # Always connect any disconnected connectors before going on the next step. F-11 Related electric circuit diagram 20-203 YES 1 3 YES Is voltage between C03 (9) and chassis Is resistance normal?
YES between terminals of 2 knob switch normal? • Turn starting switch ON. Is voltage between • Knob switch knob switch inlet • Turn starting switch NO ON: 20 - 30V NO terminal and chassis OFF. OFF: Max. 1V normal? • Disconnect switch terminal. • Knob switch • Turn starting switch ON: Max. 1 OFF: No continuity ON. NO • 20 - 30V Cause Remedy Defective engine throttle - pump controller Defective contact, or disconection in wiring harness between knob switch outlet - M23 (2) - M22 (2) C03 (female) (9) Defective L.H. knob switch Defective contact, or disconnection in wiring harness between fuse No.
5 - H12 (16) - M22 (1) - H23 (1) - knob switch inlet Replace Repair wiring harness Replace Repair wiring harness