TROUBLESHOOTING H-MODE # In the failure modes, modes for compound operations are used when independent operations are normal M When there is an abnormality for both front and rear 20-207 Parts cusing failure Failure mode Solenoid valve Swing motor PC-EPC LS slect Pump merge-divider 2-stage relief Travel speed select Swing brake Holding brake Safety valve Suction valve Leakage, breakage inside body All work equipment, travel, swing Speeds of all work equipment, swing, travel are slow or lack power p There is excessive drop in engine speed, or engine stalls No work equipment, travel, swing move Abnormal noise generated (around pump) Auto-deceleration does not work Fine control ability is poor or response is poor p Work equipment Boom is slow or lacks power Arm is slow or lacks power p Bucket is slow or lacks power p Boom does not move Arm does not move Bucket does not move Excessive hydraulic drift Escessive time lag (engine at low idling) p Other equipment moves when single circuit is relieved Lack of power when pressure rises p In L/O, F/O modes, work equipment speed is faster than specified speed p p Compound operations In compound operations, work equipment with larger load is slow In swing + boom (RAISE), boom is slow p In swing + travel, travel speed drops excessively Travel system Travel deviation Deviation excessive Deviation is excessive when starting Travel speed is slow p Steering does not turn or lacks power p p Travel speed does not switch or is faster than set speed p p Does not move (one side only) Swing system Does not swing Both left and right p p p One direction only p Swing acceleration is pour or swing speed is slow Both left and right p One direction only p p Excessive overrun when stopping swing Both left and right p One direction only p Excessive shock when stopping swing (one direction only) Excessive abnormal noise when stopping swing p p Exessive hydraulic drift of swing When brake OFF p p p When brake ON p p Swing speed is faster than specified swing speed p p