TROUBLESHOOTING H-MODE H-1 Speeds of all work equipment, swing, travel are slow # Carry out troubleshooting in the H/O mode. # Check that no abnormal noise is being generated from the main pump before carrying out troubleshooting. (If there is any abnormal noise, carry out troubleshooting for H-4.) YES Is LS differential pressure normal? 5 YES 4 See TESTING AND ADJUSTING. LS differential pressure YES Is input pressure of servo piston approx. 3/5 of main circuit pressure? NO 3 Engine at high idling Power max. mode L.H. knob switch ON Arm IN relief See Note 1. 8 YES YES Is output pressure of LS-EPC vlave normal? Does condition become normal when servo assmebly is replaced?
NO 2 0 - 0.4 MPa (0 - 4 kg/cm 2 ) Engine at high idling Arm IN relief Distribution of servo (LS valve) and piston pump (servo piston) NO YES Is main pump relief pressure normal? NO 30.4 - 33.8 MPa (310 - 345 kg/cm 2 ) Engine at high idling Arm IN relief 9 YES 1 Does condition become normal when main relief valves are adjusted? Is control pump ciruit pressure normal? NO 10 YES 30.4 - 33.8 MPa (310 - 345 kg/cm 2 ) Engine at high idling Arm IN relief NO Does conditon become normal when become normal when unload valves are replaced in order from left to right? 2.9 - 4.9 MPa (30 - 50 kg/cm 2 ) Engine at high idling Arm IN relief Check and measure circuit oil pressure.
For details, see TESTING AND ADJUSTING. NO NO # The PPC control circuit oil pressure is reduced by self-reducing pressure valve. Note 1: Measuring servo piston inlet port pressure in Item No. 4 Measure the input pressure to the large diameter end of the servo piston when the arm is relieved in the power max. mode. (Approximately 17.6 MPa (180 kg/cm 2 )) Basically, the pressure at large diameter end is approximately 3/5 of the small diameter end. (For details, see TESTING AND ADJUSTING). 20-211