TROUBLESHOOTING H-MODE H-2 There is excessive drop in engine speed, or engine stalls # Carry out troubleshooting in the H/O mode. # Check that the main relief pressure is normal. Note 1: Replace the servo valve assembly on the defective side with a new part, and if the engine speed is lower than the reference value below, carry out troubleshooting for S mode (engine). # Engine speed (reference) at arm IN relief when engine and pump are normal. H-3 No work equipment, travel, swing move 20-213 Engine speed at arm IN relief Conditions Min. 2,200 rpm • Engine at high idling • Power max. mode • L.H. knob switch ON 2 YES When main pump YES pressure pickup plug 1 is removed, does oil come out?
Is safety lock valve • Crank with starting NO working properly? motor. NO Cause Remedy Defective control pump, defective control relief valve, defective control circuit, or defective main piston pump Defective damper Defective operation of safety lock valve or safety linkage Replace Replace Adjust