TROUBLESHOOTING H-MODE H-7 Boom is slow or lacks power # When travel and swing speeds are normal. # Carry out troubleshooting in the H/O mode. 6 YES YES Does LS shuttle valve move smoothly? 5 Check LS shuttle for R.H travel and bucket NO YES Is relief pressure of front and rear pumps normal when boom RAISE circuit is relieved? 30.4 - 33.8 MPa (310 - 345 kg/cm 2 ) Engine at high idling Rear is low NO Both front and rear are low 4 YES Is pressure compensation valve for boom normal, or does pressure compensation piston move smoothly? 3 It is also possible to interchange with other compensation valve. See Note 2. YES Does control valve spool for boom move smoothly?
2 NO YES Is output pressure of PPC valve normal? 1 NO Is pressure switch for boom RAISE, LOWER normal? Min. 2.7 MPa (28 kg/cm 2 ) Engine at high idling Operate boom. NO See Judgement Table. (Bit pattern 20 (3) (4)) See Note 1. NO Note 1: If auto-deceleration is canceled when boom RAISE or boom LOWER is operated, system is normal. Note 2: After inspection, do not forget to return the interchanged valves to the original position. Note 3: 16.7 ± 1.5 MPa (170 ± 15 kg cm 2 ). 20-217