Komatsu — eebm001902 a3.pdf

TROUBLESHOOTING H-MODE H-8 Arm is slow or lacks power # When travel and swing speeds are normal. # Carry out troubleshooting in the H/O mode. 6 YES YES Does LS shuttle valve move smoothly? 5 YES Is relief pressure of front and rear pumps normal when arm circuit is relieved? Check LS shuttle for L.H. travel, boom, R.H. travel and bucket NO Is pressure compensa- tion valve for arm nor- mal, or does pressure compensation piston move smoothly: 4 30.4 - 32.4 MPa (310 - 330 kg/cm 2 ) Engine at high idling Rear is low YES NO 3 It is also possible to interchange with other compensation valve. See Note 2. Both front and rear are low YES NO Does control valve spool for arm move smoothly?

2 YES Is output pressure of PPC valve normal? NO Is pressure switch for arm IN, OUT normal? 1 Min. 2.7 MPa (28 kg/cm 2 ) Engine at high idling Operate arm. NO see Judgement Table. (Bit pattern 20 (5)p, (6)) See Table 1. NO Note 1: If the auto-deceleration is canceled when arm IN or arm OUT is operated, the system is normal. Note 2: After inspection, do not forget to return the interchanged valves to the original position. 20-219