TROUBLESHOOTING M-CODE d) (coolant temperature) flashes M-12 d) Related electric circuit diagram e) (fuel) flashes 20-259 # Check that the coolant temperature is normal before carrying out troubleshooting YES 2 When P07 is discon- nected, does only YES level 1 (left end) of 3 YES gauge display light up? Is resistance • Start engine. between C03 1 (female) (1) - (16) - NO chassis normal? Is coolant tempera- • Turn starting switch ture in red range? OFF. NO • Disconnect C03 and • Start engine and run P07. at mid-range or • Max.
1 Mq above NO Cause Remedy Defective coolant tempera- ture sensor system (see M- 26) Defective engine throttle - pump controller Short circuit of wiring harness between, C03 (female) (1) and P07 (female) (1) and wiring harness between C03 (female) (16) and P07 (female) (2) Defective monitor panel - Replace Repair or replace Replace # Check that there is fuel before carrying out troubleshooting. YES 2 When P06 (female) (1) is connected to chassis YES ground, do all lamps to level 14 (right end) of 3 YES gauge display light up? • Start engine. Is voltage between 1 • Wait for approx. 2 C03 (2) and (16) minutes. (The fuel NO normal? level may vary, so the Is fuel gauge in red range?
display is given a • Connect P06 (female) NO time delay.) (1) to chassis ground. • Turn starting switch ON. • Max. 0.3 V • Start engine. NO Cause Remedy Defective fuel level sensor system (see M-25) Defective engine throttle - pump controller Defective contact or disconnection in wiring harness between C03 (female) (2) and P06 (feamle) (1) Defective monitor panel - Replace Repair or replace Replace