Komatsu — eebm001902 a3.pdf

DISASSEMBLY AND ASSEMBLY FUEL INJECTION PUMP 10. Disconnect tube (12) between fuel filter and fuel injec- tion pump. 11. Remove lubrication tube (13). 12. Remove mounting bolt (14) of support bracket at bot- tom of fuel injection pump. 13. Using tool A2 , rotate engine in normal direction, and push No. 1 cylinder compression top dead center po- sitioning pin (15) into gear. # Push the pin lightly against the gear and rotate the engine slowly. # After determining the TDC position, check if the mesh- ing of the timing pin has come out. 14. Remove 2 fan belts (16), then move fan tension “3 pulley (17) and adjustment bar (18) towards fan shaft.

# Loosen mounting bolt (19) of adjustment bolt bottom bracket (20), then loosen adjustment bolt (21). 15. Turn cap (22) and remove. 3 16. Remove fuel injection pump. For details, see engine shop manual. 30-17