DISASSEMBLY AND ASSEMBLY RADIATOR • HYDRAULIC COOLER 9. Disconnect radiator support rods (12) and (13). 10. Disconnect radiator lower hose (14) and heater hose (15), then remove intermediate clamp (16) of radiator lower hose. 2 11. Sling radiator and hydraulic cooler assembly (17), re- move bottom mounting bolts, then lift off radiator and hydraulic cooler assembly. # When raising the radiator and hydraulic cooler assem- bly, check the position carefully and do not let it hit the fan when removing it. Radiator, hydraulic cooler assembly: 147 kg Installation Carry out installation in the reverse order to removal. Radiator hose band clip:
8.83 ±± 0.98 Nm (0.9 ±± 0.1 kgm) Refilling with coolant # Add coolant through the water filler to the specified level. Run the engine to circulate the coolant through the system. Then check the coolant level again. Refilling with oil (hydraulic tank). # Add oil through the oil filler to the specified level. Run the engine to circulate the oil through the system. Then check the oil level again. 30-31 1 2