DISASSEMBLY AND ASSEMBLY ENGINE, MAIN PUMP 19. Remove fan (37) and move towards radiator. 20. Remove radiator upper hose (38), radiator lower hose (39), heater hose (40), and air cleaner connector (41). 21. Remove engine mounting bolts, then raise engine and main pump assembly (42) slowly and lift off. # When removing the engine and main pump assembly, check that all the wiring and piping has been discon- nected. Engine, main pump assembly: 770 kg. 1 Installation Carry out installation in the reverse order to removal. 1 # Set the engine mounting rubber as shown in the dia- gram, then install the engine and main pump assem- bly. Engine mounting bolt:
227 ± 32 Nm (28.3 ± 3.3 kgm) Refilling with coolant. # Add coolant through the water filler to the specified level. Run the engine to circulate the coolant through the system. Then check the coolant level again. Refilling with oil (hydraulic tank) # Add oil through the oil filler to the specified level. Run the engine to circulate the oil through the system. Then check the oil level again. Bleeding air. # Bleed air from the main pump. For details, see TEST- ING AND ADJUSTING, Bleeding air. 30-35