STRUCTURE AND FUNCTION HYDRAULIC PUMP 4. When servo piston balanced a. Let us take area receiving the pressure at the large diameter end of the piston as A1 , the area receiving the pressure at the small diameter end as A0 , and the pressure flowing into the large diameter end of the piston as Pen . If the main pump pressure PP of the LS valve and the combined force of force Z of spring (4) and LS pressure PLS are balanced, and the relationship is A0 x PP = A1 x Pen , servo piston (11) will stop in that position, and the swash plate will be kept at an intermediate position.
(It will stop at a position where the opening of the throttle form port D to port E and from port C to port D of spool (6) is approximately the same.) b. At this point, the relationship between the area receiving the pressure at both ends of piston (11) is A0:A1 = 1: 2, so the pressure applied to both ends of the piston when it is balanced becomes PP: Pen = 2:1. c. The position where spool (6) is balanced and stopped is the standard center, and the force of spring (4) is adjusted so that it is determined when PP - PLS = 2.2 MPa (22.5 kg/cm 2 ).
However, if PSIG is applied to port G , the balance stop position will change in proportion to pressure PSIG between PP - PLS = 2.2 - 0.74 MPa (22.5 - 7.5 kg/cm 2 ). 10-29