Komatsu — eebm001902 a3.pdf

DISASSEMBLY AND ASSEMBLY RECOIL SPRING ASSEMBLY OF RECOIL SPRING ASSEMBLY 1. Assembly of piston assembly 1) Assemble ring (14) and U-packing (13) to piston (9), and secure with snap ring (12). 2) Tighten valve (11) temporarily, and secure with lock plate (10). 2. Assembly of recoil spring assembly 1) Using tool H2 , assemble dust seal (8) to cylinder (7). 2) Assemble cylinder (7) and yoke (6) to spring (5), and set in tool H1. Sliding portion of cylinder: Grease (G2-LI) 3) Apply hydraulic pressure slowly to compress spring, and tighten nut (4) 50 that installed length of spring is dimension “ a ”, then secure with lock plate (3) # Installed length “ a ” of spring:

648 mm 4) Remove recoil spring assembly (1) from tool H1 . 3. Assemble piston assembly (2) to recoil spring as- sembly (1). Piston sliding portion and wear ring: Grease (G2-LI) # Assemble the cylinder assembly so that the mounting position of the valve is 900 to the side. # Fill the inside of the cylinder with approx. 200 cc of grease (G2-LI) 1 then bleed the air and check that grease comes out of the grease hole. 30-68