Komatsu — eebm001902 a3.pdf

DISASSEMBLY AND ASSEMBLY CONTROL VALVE Disassembly # The set pressure of the safety valve cannot be adjusted when it is installed on the machine, so do not disassemble. This section explains the procedure for the 6-spool valve. 1. Remove the main relief valve (2). 2. Unload valves, safety suction valves, suction valves. a. Remove unload valve (1) and (17). b. Remove safety-suction valves (23), (22), (27), (18) and (20). c. Remove suction valves (25), (24), (21), (26) and (19). 3. Pressure compensation valves. # Before removing any pressure compensation valve, check and mark its mounting position. a. Remove bucket DUMP (8), R.H. travel REVERSE (7), boom RAISE (6), L.H.

travel REVERSE (4), and arm OUT pressure compensation valve (3). b. Remove bucket CURL (10), R.H. travel FORWARD (11), boom LOWER (12), left swing (13), L.H. travel FORWARD (14), and arm IN pressure compensation valve (15). # After removing the pressure compensation valves, remove the check valves (35) from each pressure com- pensation valve mount. 4. Remove LS select valve (38). 5. LS Shuttle valves, pump merge/divider valve, boom regeneration valve. a. Remove LS shuttle valves (79) and (81). b. Remove pump merge/divider valve assembly (80), then remove boom regeneration spring (61) and boom regeneration valve (62). 6. Remove covers (9) and (16). 7. Arm control valve. a.

Remove case (70), then remove spring (74) and retainer (69). b. Remove case (66), then remove spring (67) and retainer (78). c. Remove spool assembly (68). 8. Swing control valve a. Remove case (40), then remove spring (39) and retainer (41). b. Remove case (43), then remove spring (36) and retainer (42). c. Remove spool assembly (37). # Do not disassemble spool assembly (37). 9. R.H. travel, L.H. travel control valves. a. Remove case (47), then remove spring (46) and retainer (48). b. Remove case (50), spring (44), and retainer (49). c. Remove spool assembly (45). # Do not disassemble spool assembly (45). 10. Boom control valve a. Remove case (57), then remove spring (55) and retainer (60).

b. Remove plug (58), then remove piston (59) and spring (56). c. Remove case (64), then remove spring (53) and retainer (63). d. Remove spool assembly (54). # Do not disassemble spool assembly (54). 11. Bucket control valve. a. Remove case (30), then remove spring (31), and retainer (32). b. Remove case (34), then remove spring (28) and retainer (33). c. Remove spool assembly (29). # Do not disassemble spool assembly (29). 12. Remove plate (75), then remove arm regeneration spring (76) and arm regeneration valve (77). 30-92