Komatsu — eebm001902 a3.pdf

DISASSEMBLY AND ASSEMBLY WORK EQUIPMENT • SWING PPC VALVE Assembly 1. Assemble valve (13) to body (14). 2. Assemble shim (12) and spring (11) to valve (13). # When assembling spring (11), set the end with the small coil diameter (inside diameter) at shim (12) end. 3. Assemble spring (10), retainer (9), and piston (8). # The number of loops in the coil for spring (10) is differ- ent for each of the hydraulic ports below, so be careful when installing. # The position of each port is marked on the bottom of the valve body. Piston: Grease (G2-L1) # When assembling piston (8), coat the outside of the piston and the inside of the hole in the body with grease. 4.

Fit O-ring to collar (7) and assemble in body (14), then install seal (6). 5. Install plate (5). Mounting bolt: 13.2 ± 1.5 Nm (1.35 ± 0.15 kgm) 6. Install joint (4). Sliding portion of joint: Grease (G2-L1) Female thread of body: Thread tightener (LT-2) # Coat two places on the female thread with one drop each of Loctite as shown in the diagram below. Joint: 44.1 ± 4.9 Nm (4.5 ± 0.5 kgm) # Keep strictly to the tightening torque. 7. Assemble boot (3) and disc (2), and tighten with nut (1). Contact surface of pistion and disc: Grease (G2- L1), 0.3 - 0.8 cc. Nut: 112.7 ± 14.7 Nm (11.5 ± 1.5 kgm) # After assembling the disc, adjust the height of the disc.

For details, see TESTING AND ADJUSTING, Adjusting PPC valve. 30-106 Position of port Free length of spring P1, P2 44.4 mm P3, P4 42.4 mm