DISASSEMBLY AND ASSEMBLY BUCKET CYLINDER INSTALLATION OF BUCKET CYLINDER ASSEMBLY Carry out installation in the reverse order to removal. # When tightening the locknut, tighten so that the clearance between the plate and nut is 0.5 - 1.5 mm. Inside surface of bushing when assembling pin: anti-friction compound (LM-P) Greasing after assembling pin: Grease (LM-G) When aligning the position of the pin hole, never insert your fingers in the pin hole. # Adjust the shim thickness so that the clearance between cylinder bottom (6) and bracket (7) is be- low 1 mm. # Standard shim thickness: 0.8 mm, 1.5 mm. Inside surface of bushing when assembling pin:
anti-friction compound (LM-P) Greasing after assembling pin: Grease (LM-G) When aligning the position of the pin hole, never insert your fingers in the pin hole. # Adjust the shim thickness so that the clearance between cylinder bottom (6) and bracket (7) is be- low 1 mm. # Standard shim thickness: 0.8 mm, 1.5 mm. Refilling with oil (hydraulic tank) # Add oil through the oil filler to the specified level. Run the engine to circulate the oil through the system. Then check the oil level again. Bleeding air # Bleed the air from the cylinder. For details, see TESTING AND ADJUSTING, Bleeding air from hydraulic cylinder. 30-114