DISASSEMBLY AND ASSEMBLY BUCKET - ARM BUCKET - ARM Removal Extend the arm cylinder piston rod approx. 200 mm, lower the work equipment to the ground, and set the safety lock lever to the LOCK position. 1. Set block a between arm cylinder and boom. 2. Remove plate, then remove arm cylinder head pin (1). 3. Start engine, and retract piston rod, then tie piston rod with wire to prevent it from coming out. 1 Release the remaining pressure in the hydraulic cir- cuit. For details, see TESTING AND ADJUSTING. Releasing remaining pressure in hydraulic circuit. 4. Disconnect 2 hoses (2) and 2 hoses (3) # Install blind plugs at the male end in the disconnected hoses.
# Hoses (3) are for machines equipped with an addi- tional attachment circuit. 5. Raise bucket and arm assembly, remove plate, then remove connecting pin (4) between arm and boom, and remove bucket and arm assembly (5). # There are shims installed, so check the number and thickness, and keep in a safe place. 2 Bucket, arm assembly: 2210 kg 30-127