STRUCTURE AND FUNCTION SAFETY-SUCTION VALVE FOR SERVICE VALVE 2. At neutral and when load pressure P2 is low (when moving down under own weight (boom LOWER or arm IN)). Note: When load pressure P2 is lower than out- put pressure PR of the self-reducing pres- sure valve. a. Valve (2) receives force in the direction to close the passage from port P1 Ў P2 from spring (3) and pressure PR (when engine is stopped, the pressure is 0 MPa [[0 kg/ cm 2 ]]).
However, when hydraulic oil flows in from port P1 , the pressure is balanced so that pressure P1 = force of spring (7) + (area Ш d X pressure PR ), and the opening from port P1 Ў P2 is adjusted so that pres- sure P1 is kept at a certain value above pressure PR . b. When pressure PR goes above the set pressure, poppet (5) opens, and the hy- draulic oil flows in the following circuit: port PR Ў hole a inside spool (8) Ў opening of poppet (5) Ў tank port T. As a result, a pressure difference is created on both sides of hole a inside spool (8), so spool (8) moves in the direction to close the opening from port P1 Ў PR.
Pressure P1 is re- duced to a certain pressure (set pressure) by the amount of opening at this point, and is supplied as pressure PR . (See figure at right). 3. When the load pressure P2 is high. a. If load pressure P2 increases and the pump discharge amount also increases because of digging operations, pressure P1 also increases (pressure P1 >> force of spring (7) + area Ш d X pressure PR ), so valve (2) moves to the right to the end of the stroke. As a result, the amount of open- ing from port P1 Ў P2 increases and the resistance in the passage is reduced, so the loss of engine horsepower is reduced. b.
If pressure PR goes above the set pres- sure, poppet (5) opens and the hydraulic oil flows in the following circuit: port PR Ў hole a inside spool (8) Ў opening of poppet (5) Ў tank port T. As a result, a pressure difference is created on both sides of hole a inside of spool (8), so that spool (8) moves in the direction to close the opening from port P1 Ў PR. Pressure P1 is reduced to a certain pressure (set pressure) by the amount of opening at this point, and is sup- plied as pressure PR . (See figure at right) 10-46