Komatsu — eebm001902 a3.pdf

STRUCTURE AND FUNCTION CLSS Operation Simultaneous operation with work equipment under heavy load (boom RAISE, etc.) 1. The pump pressure and LS pressure are deter- mined by the pressure of the other work equip- ment, but the cylinder port pressure becomes the actuating pressure of the attachment. When the difference between the pump pressure and the cylinder pressure is less than the force of spring (5), then balance of the force acting on valve (1) is as follows. P X A1 = P X A2 + LS (A2 - A1) + F A1: Cross-sectional area of diameter D1 A2: Cross-sectional area of diameter D2 F: Force of spring 2.

If the difference between pump pressure P and the cylinder pressure becomes greater than the force of spring (5), poppet (4) is pushed to the right and the passage opens, so the pump pas- sage is connected to the cylinder port through throttle a , chamber g and passages b and c , and the oil flows to the cylinder port. When this happens, a differential pressure is formed be- tween the upstream and downstream sides of throttle a , and the pressure in chamber g goes down, so the force pushing valve (1) to the left is reduced. In other words, the area ratio be- comes smaller, so valve (1) moves to the right and increases the flow from the pump to the cylinder. 10-64