Komatsu — BEFORE STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS (2) is dirty or it is difficult to see the inside, clean transparent cap (2) when replacing fuel (4) has been removed during the cleaning operation, coat the O-ring with grease and position (S). 3 - 111 Checks Before Star Always check the item s in this section before sta rting the engine each Drain Water And Sedim ent from Fuel Tank he right of the machine. 1. Open the door at t 2. Set a container un 3. Turn drain valve (2 sediment and wat the fuel. 4. When clean fuel co (S) position. 5. Close the door. 1. Open the door at t 2. Set a container un der drain hose (1) to catch the drained fuel.

) to the OPEN (O) position and drain a ll the er accumulated at the bottom together with 4. When clean fuel co mes out, turn drain valve (2) to the CLOSE Check for Water and Sediment in Water Separator, Drain Wate r ne. 1). 1. Open the pump ro The water sepa 2. It is possible to jud by looking through sediment collected drain water under 3. Loosen drain valve 4. When fuel starts t valve (4) immediat om door on the right side rator forms one unit with fu of the machi el pre-filter ( ge the water level and am transparent cap (2). If the ount re is of any sediment water or at the bottom, set a container to catc h the drain hose (3). (4) and drain the water.

o drain from drain hose (3), tighten drain ely. NOTICE If the water inside transp arent cap (2) freezes, check th at the frozen water has melted completely, then use the procedure above t o drain the water. REMARK If transparent cap ( pre-filter cartridge ( When the drain val tighten until it conta Adjustment of Drain Valv If drain valve (4) is stiff , coat the O-ring portion o f the drain v alve with grease to make the 1. Turn the valve (6) at the bottom of the fuel ta nk to the CLOSE