. OPERATION MACHINE OPERATIONS AND CONTROLS operating the of the engine correct 3 to monitor 3 - 134 Breaking-in the New M achine een thoroughly adjusted and tested before shipment from the factory. NOTICE Your Komatsu machine has b machine under full load befor e breaking the machine in can advers ely affect th e performance and shor Be sure to break in the machi ne for the initial 100 hours (as indicat ed on the service meter). Make sure that you fully un derstand the content of this manua l, and pay c areful attention to the following points when breaking in the machine. Run the engine at idle fo r 15 seconds after starting it.
Du ring this time, do not operate the control levers or fuel control dial. utes after starting it up. avy loads or at high speeds. Idle the engine for 5 min Avoid operation with he Immediately after startin g the engine, avoid sudden starts, sudden acceleration, unnecess ary sudden stops, and sudden changes in dire ction. Engine Warm Up NOTICE Do not accelerate the engin e suddenly until the warm-up operati been completed. Do not run the engine at low idling or high idling under no load fo than 20 minutes. This will and will also have an adv have an adverse effect on the enviro erse effect on the internal structure engine.
If it is necessary t o run the engine at idling for more t minutes, apply a load from time to time or run at a mid-range sp After the engine starts, do n ot start operating the machine im mediately. First, carry out the fol lowing operations and checks. 1. This machine is equip below 55 °C after the e automatic warm-up ope speed. If the engine water te engine speed drops to ped with an automatic engine warm-up system, so if the engine water temperature is ngine is started, the engine war m-up operation starts automatica lly.
When the engine ration starts, the engine speed is maintained at a speed higher tha n the normal low idling mperature goes above 55 °C , the automatic warm-up operation is cancelled and the the normal low idling speed. 2. After 10 minutes wa coolant temperature temperature. If it displays low tempe carry out additional w displays the correct te (A) Display when temp (B) Display when temp rm-up operation, Check that e monitor (1) displays the c rature, use the procedure in Ste arm up of the engine until the m mperature. erature is correct: Monitor backg (C) is blue erature is low: Monitor backgrou is white