. OPERATION MACHINE OPERATIONS AND CONTROLS Hydraulic Equipment Warm Up WARNING Before carrying out the warming-up operation for the hydraulic 3 - 136 equipment, turn the swin g lock switch ON, check on the mon itor that the swing lock is actuated, t When warming up the person or obstacle in th hen start the warming-up operatio hydraulic equipment, check that e surrounding area, then sound t n. there is no he horn and start the operation. Carry out the warming-u p operation for the hydraulic equipment until the hydraulic oil tempera ture monitor displays the correct t emperature.
(When the hydraulic oil te mperature is low, the low tempera ture display shown in the diagram on the right is given. (A) Display when tempera ture is correct: Monitor backgroun d (C) is blue (B) Display when temper ature is low: Monitor background (C) is white) The warming-up operatio n for the hydraulic equipment is ne cessary not only for the circuit betw een the pump and cylinders and between the pump and motor, but als o for the control circuits. Do not c arry out the operation just for one c ylinder or motor, or the operation just in one direction.
Carry out the operation in all directions for all the work bucket), swing, travel, and attachment (if ll the work equipment (boom, arm, equipped). 1. Check that engine c oolant temperature monitor (1) displays ure. perature is correct: Monitor background the correct temperat (A) Display when tem (B) Display when tem If it displays low tem the engine until en displays the correct t For details of the pr 3-134)". the correct temperat (A) Display when tem ackground (C) is blue ground (C) warm up of perature is low: Monitor back is white perature, carry out additional the engine until en displays the correct t gine coolant temperature monitor (1) emperature.
ocedure, see "Engine Warm Up (PAGE For details of the pr 3-134)".