. OPERATION MACHINE OPERATIONS AND CONTROLS WORKING MODE Working mode Applicable operations P mode Normal digging or loading operations (operations with emphasis on production) E mode Normal digging or loading operations (operations with emphasis on fuel consumption) L mode Aligning position (fine control operations) B mode Breaker operations ATT mode Operations with the crusher or other double-acting action attachment NOTICE If breaker operations are carried out in a mode other than the breaker mode, there is danger of breakage of the hydraulic equipment. Do not carry out breaker operations in any mode except the breaker mode. 1.
If working mode selector switch (1) is pressed, the working mode selection screen is displayed on the monitor. 3 - 154 Working Mode Use working m ode selector switch (1) t o select th e working mode that matches the operatin g conditions or pu rpose This will make it possible t o carry out operations efficiently Use the followi ng procedur e to select the most e fficient working mode. When the starti ng switch is turned ON, the worki ng mode i s set to the mode that was in op eration when the s tarting switch was l ast turned OFF Use the workin g mode swit ch to set th e mode to the most efficien mode to match the type of work