. OPERATION MACHINE OPERATIONS AND CONTROLS TRAVELING ON SLOPES WARNING Turning or operating the work equipment when working on slopes may cause the machine to lose it balance and turn over, so avoid such 3 - 161 operations. Itis particularly dangerous to s If such operations have to be p wing downhill when the bucket is loaded. erformed, pile soil to make a platform (A) on the slope so the machine i s kept horizontal during operatio n. Do not work on a slope cover ed with the steel plates. Even wit h slight slopes there is a hazard that t he machine may slip. eep slopes. There is a danger that the et approx.
20 to 30 cm (8 to 12 in) from the Do Do not travel downhill in rever Never turn on slopes or travel Always go down to a flat plac se. across slopes. e to perform these operations. It may be longer, but it will ensure safet y. Always operate or travel in su ch a way that it is possible to sto p safely at any time if the machine slip s or becomes unstable. When traveling uphill, if the sh oes slip or it is impossible to trav el uphill using only the force of the trac ks, do not use the pulling force of the arm to help the machine travel uph ill. There is danger that the mach ine may tur n over. 1.
When traveling down ste ep hills, use the travel lever a nd fuel c a p e ontrol dial to keep the tra vel speed low. When travelin g down steep hill of more than osture shown in the di ngine speed. 15°, set the work equipment 2. When traveling up a stee p hill of more than 15°, set th e work e quipment to the posture shown in the diagram on the right.