. OPERATION MACHINE OPERATIONS AND CONTROLS OPERATION MACHINE OPERATIONS AND CONTROLS 3. Lower the bucket horizontally until the bottom touches the ground. MACHINE INSPECTION AFTER DAILY WORK 3 - 170 4. Set lock lev er (3) in the LOCK positi 5. Check the engine cooling water te mperature and engine oil s in the red range, allow it oil pressure wi If the coo to cool u the engin see "TR If the eng immediat see "TR th the machine monitor. lant temperature gauge i ntil the indicator enters th e. For details of the insp OUBLES AND ACTIONS ine oil pressure monitor e green range, t ection and actio (PAGE 3-192)". lights up, stop th hen stop n to take, e engine ely.
For details of the ins pection and actio n to take, OUBLES AND ACTIONS (PAGE 3-192)". 6. Stop the en gine. For details on the p rocedure for stoppin g the engine, see "STOPPING THE ENGI NE (PAGE 3-144)". 1. Walk aroun d the machine and check the work equipment , machine exterior, and under carriage, also check for any leakag e of oil or coolant. If any p roblems are found, r epair 2. Fill the fuel 3. Check the e ngine compartment for p aper and debris. Clean ou t any paper and debris t 4. Remove an y mud affixed to the und