Komatsu — DISCHARGED BATTERY

. OPERATION TROUBLES AND ACTIONS DISCHARGED BATTERY WARNING 3 - 195 It is dan gerous to charge a battery when installed o n a machine. Make sure th at it is removed be fore charging. ngine and turn the When c hecking or handli ng the battery, stop the e starting switch key to the OFF position. The bat tery generates hyd rogen gas, so there is a h azard of explosion. Do not bring lighted cigar ettes near the battery, or d o anything that wil cause s parks. Battery electrolyte is dilut e sulfuric acid, and it will a ttack your clothes and ski n. If it gets on your clothes or on your skin, i mmediately wash it off with a large amount of water.

If it gets in your eye s, wash it out with fresh w ater and consult a When gloves. When r emoving the batter y, first disconnect the cab le from the ground (normal ly the negative (-) t erminal). When installing, install the positive (+) term inal first. If a tool touches the posit ive terminal and the chass is, there is danger that it w ill cause a spark, so be extremely careful. If the te rminals are loose, there is danger that the def ective contact may generat e sparks that will cause an explosion. When r emoving or installi ng the terminals, check w hich is the positive (+) term inal and which is t he negative (-) terminal.

Battery Removal and Installation nd cable (normally connected to the negative (-) terminal). Before removing the b attery, remove the grou nd cable (normally connected t o the negative If any t ool touches bet ween the positive termin al and the chassis , there is a h azar d of spark s being generated. When installing the bat tery, connect the groun d cable last. ery hold-down. 9.8 to 19.6 Nm (1 to 2.0 kgm, 7.2 to 14.8 lbft) When replacing the ba ttery, secure it with batt Tighte ning torque: Tigh tening battery terminal: 9.8 to 19.6 Nm (1 to 2.0 kgm, 7.2 t o 14.8 lbft