Komatsu — MAINTENANCE INFORMATION

. MAINTENANCE MAINTENANCE INFORMATION 4 - 3 Dusty Jobsite follows: o see if the air cleaner is dirty or clogged. avoid clogging. ently. ally the starting motor and alternator, to avoid accumulation of dust. When working at dusty worksites, do as Inspect the dust indicator frequently t Clean the radiator core frequently to Clean and replace the fuel filter frequ Clean electrical components, especi ally the starting motor and alternator, to avoid accumulation of d When checking and replacing the oil or filters, move the machine to a place where there i s no dust an d take care to prevent dust from entering the sys tem.

Avoid Mixing Lubricants If a different brand or grade of oil has to b e added, drain the old oil and replace all the oil with the new bra nd or grade of oil. Never mix different brand or grad e of oil. Locking the Inspection Covers Lock inspection cover securely into po sition with the lock bar. If inspection or maintenance is performed with with inspection cover not locked in position, there is a danger that it may be suddenly blow shut by t he wind and cause injury to the worker. Hydraulic System - Air Bleeding When hydraulic equipment has been re paired or replaced, or the hydraulic piping has been removed a nd installed again, the air must be bled from the circu it.

For details, see "BLEEDING AIR FROM HYDRAULI C SYST EM (PAGE 4-44)". Hydraulic Hose Installation When removing parts at locations w replace with new parts. When doing this, be careful not to for here there are O-rings or gasket seals, clean the mounting surface, and get to assemble the O-rings and gaskets. When doing this, be careful not to for When installing the hoses, do not twi st them or bend them sharply. If they are installed so, t heir ser vice life will be shortened extremely and they ma y be damaged.

urface, and Checks After Inspection and Maintenanc e Works If y ou forget to perform the checks after i nspection and maintenance, unexpected problems may occur, a nd this may lead to serious injury or property damag e. Always do the following: topped) ance points been forgotten? nce items been performed correctly? Checks after operation (with engine s Have any inspection and mainten Have all inspection and maintena Have any tools or parts been dro inside the machine and get caugh Are there any leakage of coolant Have any inspection and mainten Have all inspection and maintena Have any tools or parts been dro pped inside the machine?

It is particularly dangerous i f parts a re dropped t in the lever linkage mechanism. or oil? Have all nuts and bolts been tightened? erating the engine, see "TWO WORKERS FOR MAINTENANCE WHEN 38)" and pay careful attention to safety. ce items working properly? when the engine speed is raised? Are there any leakage of coolant Checks when operating engine For details of the checks when op Are the inspection and maintenan Is there any leakage of fuel or oil