Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE WARNING the distilled water, see 3. Following this, push radiator cap (1), turn it until it contacts the stopper, then remove it. 4 - 26 COOLANT is toxic. When open th If it gets in your eyes, flush your eyes with large amount of fresh water When changing the coolant or wh en handling the coolant containing COOLANT that has been drain ed during repair of radiator, please contact your Komatsu dis tributor or request a specialist compan y to carry out the operation . COOLANT is toxic. Do not let it flow into drainage ditches o COOLANT is already diluted w ith distilled water, so it is not flammable.

(For details of "COOLANT AND WATER FOR DILUTION (PAGE 4-5)"). Check t he density with a COOL Prepare a container whose cap acity is larger than the specified coolant volume to catch d Prepare a hose to use when filli 1. Stop the machine on level ground, then stop the engine. 2. Check that the coolant temp erature has gone down enough to make it possible to touch t then turn radiator cap (1) slo release the pressure. he radiator cap surface by hand, wly until it contacts the stopper to 4. Remove the undercover, th en set the container under drain t mixture. valve (2) to catch the coolan Open drain valve (2) at the b coolant. ottom of the radiator and drain the 5.

After draining the coolant, cl ose drain valve (2), and fill with city water. When the radiator is f idling to raise the temperat continue to run for approx. 1 ull, start the engine and run at low 6. Stop the engine, open drain 7. After draining the water, cle For the cleaning method, fol 8. Close drain valve (2). 9. Install the undercover. 10. Add coolant through the wa ter filler port up to the mouth of the port. For details of the COOLANT density, see "COOLANT DENSITY TAB LE". 11. Run the engine at low idling for 5 minutes to remove the air fro m the water, then run at high idling for 5 minutes. (Leave radiator cap (1) rem oved when doing this.)