Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE Adjustment WARNING 4 - 29 CHECK AND ADJUST TRACK TENSION The wear of the pins and bushings on the un orking conditions and typ e of so il, so inspect the t rack tension fr equently in order t o maintain the standard tension Stop the ma chine on firm, horizontal ground when carrying out the inspectio n and ary with Checking engine at low idle, move the machine forward a 1. Run the distance machine 2. Choose roller (2) 3. Measure the track Stand Deflec 1. Run the equal to the l round, then stop the 2. Choose wooden block (3) that will reach fr om idler (1) to carrier , then place it on top of the track. 3.

Measure the maximum deflection betwe and the botto m surface of the w ard deflection tion "a" shoul d be 10 to 30 mm ( If the track t ension is not a t the standard valu e, adjust it in the following man There is dange r of plug (1) flyi ng out under the high internal pressure of the grease. Never loosen plug (1) more than 1 turn. Never loosen any part other mounting dire ction of plug (1) If the track te nsion cannot b please contac t your Komatsu Increasing Track Tension Prepare a grease pump. Prepare a gr 1. Pump in 2. To check idle, mov of track 3. Check th adjust it 1. Pump in grease throug h grease fitting (2) with a grease pump. 2.

To check that the track tension is correct, run the engine at l ow e the machin e forward a distanc e equal to the length on ground, the n stop the machin e. 3. Check th e track tensio n again, and if the t ension is not correct, again.