. MAINTENANCE MAINTENANCE PROCEDURE REPLACE BUCKET TEETH (VERTICAL PIN TYPE) WARNING and gloves. 4 - 32 Replace the buck et teeth before t he ad apte r starts to wear. It is dangerous if the work equipment mo ves b y mista ke when t he teeth are Set the work equi pment in a stable condition, t hen st op the eng ine and set t he lock lever securely t The pins can be k nocked out only with st rong f orce, s o there is a hazard that the pin may fly out. Ch eck that there is no one in the surrounding a There is a hazard that fragments wi ll fly d uring the rep lacement work, so always wear protective equ ipment like safety glasses 1.
To make it po ssible to knock out pi n of t ooth ( 1), put blo ck (5) under the bot tom of the bucket, a nd set so that the bottom ottom surface of the bucket is horizontal. 2. Check that the work equipmen t is in a stable co ndition, th en set the lock lever to the LOCK position 3. Use a hamme r and drift to knock o ut loc k pin ( 2). (If the drift is set against rub ber pin lock (3) when it is hit, the rubber p in lock may break. Se t it against the back of the pin.) 4. After removing lock pin (2) and rubb er pin lock ( 3), check them.