. MAINTENANCE MAINTENANCE PROCEDURE NOTICE bled. C, NOTICE 4 - 45 If the air is not bled from t he swing motor, the motor bea rings ma y be damage When replacing the travel motor safety valve, please con tact your Komatsu distributor to have it rep laced and to have the air 5. Bleeding air from trav (only when oil inside tr avel motor case has been drained 1) Run the engine at low idle, remove hose (4) has flowed out, tighten it ag 2) Run the engine at low idle and swing the wor k equipment 90° to bring it to th e side of the track.
ine until the track is raised slightly from 3) Jack up the mach from the ground.Rotate Repeat this proce rotate the track eq the track under no load for 2 minutes. dure on both the left and rig ht sides, and ually both forward and in re verse. 6. Bleeding air from attac hment (when installed) I f a breaker or other att achment has been installe d, run th e engine at l ow idle and operat e the attachment peda repeatedly (approx. 10 times) until the air has be en bled f rom the attachment circuit. If the method of bleeding the air from the attachment it self is specifie d by the manufacturer, bleed the air according to the specified procedure.
After completing the air bl eeding operation, stop the eng ine, and leave the machine for 5 minutes b efore starting operations. This will remove the air bu bbles in the oil inside the hydr aulic cylinder Check that there is no leak age of oil and wipe off any oil that has been spilled. After completing the air bl eeding operation, inspect the oil level, a nd if the oil l