Komatsu — EVERY 500 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE of filter cartridge (4) and then tighten it further by 1/4 - 1/2 turns. securely to the fixed tightening angle. 8. Clean the filter holder, fill the new filter cartridge with clean fuel, coat the packing surface thinly with oil, then install to the filter holder. 4 - 58 7. When installing, apply oil to the packing s urface and bring the packing surface into contact with the seal s ch, the O-ring will be damaged and this will cause le akage of fu ugh the gap at the O-ring. To prevent these problem s, always t NOTICE When adding fuel, do not remove cap (B). Alw small holes (A) on the dirty side.

After adding fuel, remove cap (B) and install th Always fill with clean fuel. Be careful not to let the fuel. In particular, center portion is the clean cap (B) when adding fuel. Be careful not to let di portion on the clean side. 9. When installing, tighten until the packing surface contacts the seal surface of the filter holder, t hen tighte of a turn. If the filter cartridge is tightened too far, t filter cartridge is too loose, fuel will also l When tightening with a filter wrench, b he packing will be damaged and this will lead to leakage of fuel eak from the packing, so always tighten the correct e extremely careful not to dent or damage the filter. 10.

Check that the drain valve (2) is tightene 11. Turn the valve (1) at the bottom of the fu 12. After completing the replacement of filter Bleed the air as follows: where the float is at the highest position). 13. Fill the fuel tank with fuel (to the position 14. Loosen the knob of feed pump (6), pull it out, then pump it in and out until the movement becomes hea REMARK It is not necessary to remove the plug at t After the engine runs out of fuel, use the same procedure to operate feed pump (6) and bleed 15. After finishing the air bleeding, push in th e knob of feed pump (6) and tighten it. e engine and run it at low idling for 10 minutes. 16.

After replacing the filter cartridge, start th Check for leakage of oil from the filter se tightening of the filter cartridge. If there is still oil leakage, repeat Steps foreign material in the packing surface is it. al surface and tranparent cap mounting. If any oil is le aking, che 2 - 6 to remove the filter cartridge, and if any damage or emb found, replace it with a new cartridge and repeat Ste ps 7 - 17 to