Komatsu — EVERY 500 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE CLEAN AND INSPECT RADIATOR FINS, OIL COOLER FINS, AFTERCOOLER FINS,FUEL COOLER FINS, AND AIR CONDITIONER CONDENSER FINS WARNING 1. Open engine hood (1). 4 - 60 If compressed air, high-pressure w ater, or steam hits your body directly or dirt is s ent flying by the com pressed air, high-pressure water, or steam, there is danger of personal injury. Always wear protective glasses, dust mask, and o ther protective equipment. NOTICE When using compressed air for cle aning, blow it keeping some distance to avoid d amaging the fins. Da mage on the fins ca n cause water leakage and overheating.

In a dusty job site, check the fins ever y day, regardless of the mainte nance interval. 2. Loosen screw (4) and pull 3. After pulling up net (2) and up net (2) and (3). (3), clean it. (Install it again in Step 7.) 4. Check the front and rear su rfaces of oil cooler fins (5), radiator fins (6), aftercooler fins (7) and fuel cooler fins (9). If th to the fins, blow the dirt off Steam or water may be However, when carrying (high-pressure machine equipment (radiator, oil c conditioner condenser), m machine when carrying ou (high-pressure machine w there is danger that the i equipment may be deforme and breakage.

, Air conditioner condenser fins (8), ere is any mud, dirt, or leaves stuck with compressed air. used instead of compressed air. out powerful steam cleaning wash) of the heat exchange ooler, aftercooler, fuel cooler, air air aintain sufficient distance from the t the operation. If steam cleaning ash) is carried out at close range, nternal fins of the heat exchange the d, and this will cause early clogging 5. Check the rubber hose. R eplace with a new one if the hos e is found to have cracks or to check the hose clamps for be hardened by aging. In addition, looseness.