. MAINTENANCE MAINTENANCE PROCEDURE CLEAN AIR CONDITIONER FRESH/RECIRC FILTERS WARNING If compressed air scattered around dust and debris, there is danger of injury. Always wear protective equipment protective glasses and mask. Cleaning Recirculated Air Filter 1. Remove wing bolts (1) from the inspection window at the bottom rear left on the inside of the operator's cab, then take out the recirculated air filter. 2. Clean the filter with compressed air. If there is oil on the filter, or if the filter is extremely dirty, wash it in a neutral agent. After rinsing it in water, dry it thoroughly before using it again. Replace the filter with a new part every year.
If the clogging of the filter cannot be removed by blowing with air or washing in water, replace the filter immediately. The RECIRC filter must be installed facing in the correct direction. Install it so that the projecting part faces the front of the machine. Cleaning Fresh Air Filter 1. Use the starting switch key to open cover (2) at the rear left of the operator's cab, then open cover (2) by hand and remove filter (3) inside the cover. 2. Clean the filter with compressed air. If there is oil on the filter, or if the filter is extremely dirty, wash it in a neutral agent. After rinsing it in water, dry it thoroughly before using it again. Replace the filter with a new part every year.
If the clogging of the filter cannot be removed by blowing with air or washing in water, replace the filter immediately. 3. After cleaning, return filter (3) to its original position and close the cover. Use the starting switch key to lock the cover. Do not forget to remove the starting switch key. 4 - 62 uch as NOTICE A s a guideline, the filters should be cl eaned every 500 hours, but on dusty jobsites , clean the filters REMARK If the filter becomes clogged, the a ir flow will be reduced, and there will be a n abnormal nois e from the air conditioner unit.