Komatsu — EVERY 1000 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE REPLACE HYDRAULIC OIL FILTER ELEMENT WARNING may cause burns. Wait for the NOTICE If the machine is equipped with a hydraulic breaker, the hydraulic oil will deteriorate much faster than during normal bucket operations. For details, see "MAINTENANCE INTERVAL FOR HYDRAULIC BREAKER (PAGE 4-17)" when carrying out maintenance. REMARK 4 - 67 temperature to go down b When removing the oil fill er cap, turn it slowly to release th e internal pressure, then remove it 1. Set the machine to po sture shown on the right, lowe r the work equipment to the grou nd, then stop the engine. the top of the hydraulic tank. 2. Remove the cover at 3. Remove the cap fro pressure.

Loosen 4 bolts, then r 4. cover may fly out un cover down when rem 5. After removing spring (2) and valve (3), take out ele 6. Clean the removed pa 7. Install the new elemen t in the place where old eleme nt (4) was installed. ng (2) on top of the element. 8. Set valve (3) and spri 9. Set cover (1) in positi on, push it down by hand, and install the cover with the mounti ng bolts. , then install the cover at the top of the t the engine according to "STARTING 10. Install the oil filler cap hydraulic tank. To bleed the air, star 11. TARTING ENGINE (PAGE 3-12 minutes. Stop the engine. 8)" and run the engine at low idle for 10 idle for 10 12.

Operate the machine afte r halting for more than 5 minu tes to eliminate bubbles in the 13. Check for oil leakage