. ATTACHMENTS AND OPTIONS MACHINE READY FOR ATTACHMENT ATTACHMENTS AND OPTIONS MACHINE READY FOR ATTACHMENT (a). (a) FREE: Hydraulic oil flows (direction of arrow is parallel to long direction of arm) (b) LOCK: Hydraulic oil does not flow (direction of arrow is at right angles to long direction of arm) 6 - 13 6. Remo slowly loosen oil filler cap (F) to release th e internal p ressure. 7. After checking that the oil temperature is l ow, remove the covers from the inlet port and outlet port (2 places). Be ca reful that no dirt or mud is stuck to t he hose mo uthpiece. If the O-ring is damag ed, replace it with a 8. Conn ect the hose at t he attachment side.
When doing this, chec k the direction of flo w of the oil and be careful not to make a 9. Set th e rotor of the sto p valve installed to the inlet po rt on the side f ace of the arm an d the outlet port pipi ng to FREE position Wh en setting the F REE or LOCK positi on of the st op valve or, remove bolt (2 ), turn over plate (1 ), then turn t he rotor. er setting, install plate (1) again with 10. After i nstalling the atta chment, check the oil level in t he hydraulic