DRIVING - Engine Operations WARNING CAUTION as the ambient temp reaches 41°F (5°C). The use of a winterfront above 40°F (4°C) can result in excessive coolant, engine oil, and intake air tem- peratures, which may lead to over- heating and possible engine or coolant module damage and emissions non- compliance. DO NOT work on or near the fan with the engine running. Anyone near the engine fan when it turns on could be injured. If it is set at MANUAL, the fan will turn on any time the ignition key switch is turned to the ON position. In AUTO, it could engage suddenly with- out warning. Before turning on the igni- tion or switching from AUTO to MAN- UAL, be sure no workers are near the fan.
Failure to comply may result in death or personal injury. The fan or equipment near it could be damaged if the fan turns on suddenly when you do not expect it. Keep all tools and equipment away from the fan. 4 The winterfront is designed to minimize the temperature differences across the radiator and reduce the possibility of cooling module damage. Aftermarket winterfronts may not provide the proper airflow distribution and could cause cooling module damage. Using a Winterfront CAUTION The use of a winterfront can result in excessive coolant, engine oil, and in- take air temperatures, which may lead to overheating and possible engine damage.
CAUTION How to Set the Shutdown Timer The Shut Down Timer must first be enabled. Enabling the shutdown timer is located in the Settings Sub-menu. Follow these steps to turn on the engine idle shutdown timer. The shutdown timer will default to 5 minutes (or the last value used) and can be set up to 30 minutes unless limited by the Engine Shutdown System ( Clean Idle on page 316) DO NOT operate the engine fan in the MANUAL position for extended peri- ods of time. The fan hub was designed for intermittent operation. Sustained operation will shorten the fan hub’s service life as well as reduce fuel economy. CAUTION A winterfront should only be used at temperatures below 40°F (4°C).
Use of a winterfront above 40°F (4°C) can decrease life of cooling module com- ponents. Remove winterfront as soon 140 Y53-6110-1A1 (01/21)