DRIVING - Brakes Automatic Transmissions An automatic transmission makes shifting much easier. It remains important to completely understand how to operate the transmission to optimize its efficiency. Please read the manual for your automatic transmission included with your vehicle. The air compressor on the engine will typically provide 100-130 psi (690-896 kPa) to the air tanks. The vehicle is also designed with an air dryer, which removes moisture from the compressed air in order to protect all components in the air system.
The brake system may be further enhanced by additional devices such as brake proportioning valves, antilock braking systems, or sensors designed to let you know if your brake pads need to be serviced. Certain conditions may result in the brake surfaces getting wet. Brake surfaces that are wet do not perform as well as when they are dry. There may be situations where wet brake surfaces cannot be avoided. In such situations, apply the brakes while in motion, to dry the brake surfaces. Certain conditions may result in your brake surfaces becoming overheated (above 800°F or 427°C). Overheated brakes will damage linings and drum surfaces, ultimately decreasing brake performance.
Refer to Retarders and Descending a grade to avoid overheating the brakes. Brakes Air Brake System WARNING 4 WARNING DO NOT drive through water deep enough to wet brake components, as it may cause the brakes to work less ef- ficiently than normal. The vehicle's stopping distance may be longer than expected, and the vehicle may pull to the left or right when brakes are ap- plied, which could contribute to an ac- cident involving death or personal in- jury. DO NOT leave the cab of your vehicle without applying the parking brake. The truck could roll and cause an acci- dent resulting in death or personal in- jury. Always apply the parking brake before you leave the cab.
Auxiliary Transmission If you have an auxiliary transmission, see your transmission manufacturer’s manual for its proper operation. Compressed air is delivered to the brake system through the valve at the brake pedal and is controlled with various valves and braking circuits. The brake system is designed with separate front, rear, and (when applicable) trailer circuits so that if one circuit is compromised and loses air, the other circuits will not be affected. Safety valves in each circuit will protect the other circuits in the event that a circuit loses air. 160 Y53-6110-1A1 (01/21)