PACCAR 579 — Air Suspension Ride Height

DRIVING - Axle and Suspension assist you in achieving an estimated ground load). 5. After setting the pressure to obtain the desired axle load, verify proper ground loading with the weight scale. height may result in improper interaxle U- joint working angles. This can result in premature driveline wear and driveline vibration. If it becomes necessary to reset the ride height, you may temporarily set it by following the next procedure. Proper ride height measurement and values are shown in the illustration and table below. 2. Locate the air suspension ride height valve. NOTE 4 Exceeding local, state, or federal weight limits may result in citations.

Contact your local commercial weight enforcement office for limits in your area. CAUTION Completing this procedure will enable you to safely reach the nearest author- ized dealer or repair facility to have ride height and pinion angle reset us- ing the proper equipment and techni- que. Do this as soon as possible to avoid potential driveline damage. 3. Ensure that the tractor is fully laden during this procedure. Do not use these procedures on a vehicle that is not laden (bobtail). 4. Ensure the air supply and delivery plumbing of the height control valve is consistent with the following illustrations. 5. Loosen the fasteners mounting the height control valve to its bracket.

NOTE Steerable-pusher and/or tag axle(s) will raise when the transmission is shifted into reverse or when the park- ing brakes are applied. Air Suspension Ride Height Vehicles equipped with rear or front air suspensions have their ride height and axle (pinion) angle(s) preset at the factory. These are precision settings and should not be altered. Incorrectly adjusted ride 1. Park the vehicle, engage the parking brakes and clock the wheels. 176 Y53-6110-1A1 (01/21) NOTE Suitable wheel chocks are at a mini- mum an 18-inch (46 cm) long 4x4.