PACCAR 579 — Install Engine Belt

MAINTENANCE - Engine Maintenance 3. Reinstall the oil fill cap and twist to lock it in place. Pipe and Hose Clamp Torque Values Torque specifications for engine parts. 5 Install Engine Belt You can extend the reliability and service life of your vehicle's drive belts with proper attention to installation and maintenance. Neglect could cause belt failure. The result could be the loss of the electrical or air system as well as possible engine damage from overheating. NOTE is still the same. Follow this procedure to install an accessory drive belt: 1. Route the new belt around the pulleys, and then rotate the automatic tensioner so that the idler pulley swings toward the belt routing.

The following figure shows an example of the rotation direction to release the tensioner. See the engine manufacturer's opera- tor's manual for further information on replacing engine drive belts. The images below may not appear like the configuration of the vehicle. The procedure Y53-6110-1A1 (01/21) 269 Application Type of Clamp lb-in.

N•m Radiator and Heat Exchanger Hoses Constant Torque CT-L 90-110 10.2-12.5 Heater Hoses Constant Tension not required not required Air Intake Pipes Hi Torque HTM-L 100-125 11.3-14.2 Plastic Air Intake Pipes Constant Torque CT-L 88 10.0 Charge Air Intake Hoses Flex Seal 70-100 7.9-11.3 B9296 50-60 6-7 Fuel, Oil and Water Heat Exchangers (for hoses less than 9/16 in. diameter). Miniature 3600L 10-15 1.1-1.7