MAINTENANCE - Rear Axle and Suspension If you detect rapid tire wear on the rear axles, you may have misaligned axles. If you suspect rapid tire wear, have your rear axle alignment checked and adjusted by an authorized dealer. Suspension alignment should be checked when any one of the following conditions exist: Total vehicle alignment required after a body has been installed on truck chassis.
Discovery of loose suspension fasteners (Loose, defined as any torque below the recommended torque value) Discovery of elongated holes in a suspension component Bushing replacement Excessive or abnormal tire wear Immediately after post body installation (See First Day in the Maintenance Chapter) Eaton/Dana Axle Lubrication The original mineral-based lubricant must be drained within 3,000-5,000 miles (4,800-8,000 km) on all Eaton axles. This initial change is very important because it flushes out break-in contaminants that might otherwise cause premature wear. No initial drain is required on Eaton axles that are factory filled with an Eaton-approved synthetic lubricant.
Mineral-based lubes must be drained within the first 5,000 miles (8,000 km) if converting to an Eaton-approved synthetic lube. Change the lubricant within the first 5,000 miles (8,000 km) of operation after a carrier head replacement, regardless of the lubricant type. Refer to the Eaton Field Maintenance Manual for a particular axle for lubricant specifications. See your dealer for Eaton- approved lubricant brands. Refer to the chart below for lubricant change interval. WARNING DO NOT replace U-bolts and nuts with common U-bolts or standard nuts. These parts are critical to vehicle safe- ty.
If the wrong U-bolts or nuts are used, the axle could loosen or sepa- rate from the vehicle and cause a seri- ous accident. Use only U-bolts and nuts of SAE Grade 8 specification or better. Failure to comply may result in death, personal injury, equipment or property damage. 5 Rear Axle Lubrication See the axle manufacturer's operator's manual for lubrication specifications and service intervals. Check oil level with the vehicle parked on level ground and the fluid warm. The level should be even with the bottom of the filler hole. Drive Axle - Dana Drain the lubricant while warm. Flush each unit with clean flushing oil. Change the lubricant.
Rear Axle Alignment Continual road shock and load stresses may force the rear axles out of alignment. 286 Y53-6110-1A1 (01/21)