PACCAR 579 — Driveline

MAINTENANCE - Driveline Steering Shaft Bolt Torque Specifications The steering (intermediate shaft) U-joint pinch bolt should be tightened on the first day or two of operation, then checked weekly (see Weekly Checks). The following are common torque specifications for most steering shafts. 5. Fill cap WARNING If you check the fluid with the engine and steering system COLD, the fluid level should be above the Add indicator level and should generally not exceed the middle point between the Add and Full level indicators.

If you check the fluid with the engine and steering system WARM, the fluid should NOT exceed the Full level indicator and should generally not drop below the middle point between the HOT Full and Add level indicators. 4. To add fluid, open the fill cap to the power steering reservoir and then add fluid until the fluid level is in the middle of the appropriate Minimum and Maximum level indicators. 5. Reinstall the reservoir fill cap and close the hood. If this chassis is equipped with an Electronic Stability Control (ESC) and is modified (e.g.

adding or removing an axle, converting from a truck to a tractor, converting from a tractor to a truck, changing the body, lengthening of the wheelbase and/or frame, relo- cating frame components, or modifying pneumatic or electrical ABS/ESC har- nesses) the ESC must be evaluated by a qualified technician. If you have any questions, contact your authorized dealer. Failure to comply may result in property damage, personal injury, or death. Steering U-joint Pinch Bolt 5 Pitman Arm Clamp Bolt Driveline See the driveshaft manufacturer's operator's manual for lubrication specifications and service intervals. Y53-6110-1A1 (01/21) 291 Fastener Size Torque Spec. lb-ft (N•m) 7/16 -in.

37-43 (50-58) Fastener Size Torque Spec. lb-ft (N•m) 3/4 -in. 300-320 (406-433)