E-6: ASSEMBLY OF BOOM ASSEMBLY 1. Remove the boom foot pin stopper fitted to the chassis, and pull out the pin. 2. to the chassis, and pull out the pin. Remove the boom cylinder foot pin stopper fitted * Use a forcing screw (Dia. = 24 mm, Pitch = 3.0 mm) to remove the pin. 3. and align the boom foot pin hole. Raise the work equipment assembly with a crane Work equipment assembly: 14800 kg 4. Install the boom foot pin. + Insert the boom foot pin on one side as far as it will go, then align the pin hole on the other side. When doing this, if the boom is tilted to the left * Check the clearance of the boom foot pin and or right, use a jib crane to balance the boom.
of the adjustment shims to make the clearance the outside of the machine. Decide the thickness less than 1 mm. Combine the following shim thicknesses to make the adjustment shim. M2lN-72-11210) tl.Ox3 (%21N-72-11220) t1.5~3 (Adjust with shims at one place on the outside.) 104